IROCdan330
04-23-2005, 06:54 PM
Hooker 2055s. Â*1 5/8" primaries. Â*Y-pipe. Â*3 inch catco direct fit cat.
The headers are coated, have a years worth of wear on them. Â*Very good condition. Â*The y-pipe is well...It would be alright but the coating from the cat to about a foot away from the headers is stripped, and rusted. Â*Just surface rust. Â*No potential for leaks. Â*I also snagged a bump with the y-pipe, Â*so its scraped just under the collector area. Â*The cat is a catco, summit part# CTO-9118. Â*It may be busted, before I pulled the engine/dropped the exhaust and tranny, i had a nasty rattle coming from that area, no sure if thats what it was. Â*Its also had a lot of oil smoke run through it. Â*Good candidate for a gutted cat though.
Pics of headers can be seen on my 305 here:
http://www.njfboa.org/forums/viewtopic.php?t=3506
Pic of y-pipe and cat:
http://i3.photobucket.com/albums/y93/newlevel03/0411051351b.jpg
id be asking probably about $325-$350 for all. Â*I'd include hooker install instructions with the gaskets they sent me (i didnt use them, they have a crease between ports, i assume they got folded or something). Â*I dont have the hardware to bolt the flanges to the heads though.
The headers are coated, have a years worth of wear on them. Â*Very good condition. Â*The y-pipe is well...It would be alright but the coating from the cat to about a foot away from the headers is stripped, and rusted. Â*Just surface rust. Â*No potential for leaks. Â*I also snagged a bump with the y-pipe, Â*so its scraped just under the collector area. Â*The cat is a catco, summit part# CTO-9118. Â*It may be busted, before I pulled the engine/dropped the exhaust and tranny, i had a nasty rattle coming from that area, no sure if thats what it was. Â*Its also had a lot of oil smoke run through it. Â*Good candidate for a gutted cat though.
Pics of headers can be seen on my 305 here:
http://www.njfboa.org/forums/viewtopic.php?t=3506
Pic of y-pipe and cat:
http://i3.photobucket.com/albums/y93/newlevel03/0411051351b.jpg
id be asking probably about $325-$350 for all. Â*I'd include hooker install instructions with the gaskets they sent me (i didnt use them, they have a crease between ports, i assume they got folded or something). Â*I dont have the hardware to bolt the flanges to the heads though.