90FormulaWS6
08-04-2005, 08:14 PM
I need this stuff out of here. So here's the details on them.
The heads came off of a 1990 Formula 305TPI... I had the heads stripped and hot tanked, they were very low mile heads to begin with so the valve guides didnt need to be cut and for that reason i didnt get a valve job done. The valves are stock and all seals are new. The springs are aftermarket springs that will accomodate cams up to .525" lift. They are PBM springs. The port job was done by my buddy who is a tech at a toyota dealership and builds engines. They are port matched to mr.gasket gaskets and can be bolted on like that or can be polished for a few extra cfm. The only assembly on the heads that need to be completed are the springs on one of the heads (not sure which one) but they need to be installed and come with all the hardware necessary. Also included are the old springs which if you dont want the new springs you can put the stock GM springs on.
The only thing that needs to be done to these heads is to have the new springs on the one head put on along with the rockers. After this has been done these are ready to bolt on.
$200 shipped or $175 picked up.
1997 Lt1 cam, 30k miles in good condition. Has been sitting for a year in my room and I need it gone. Ill take $25picked up/ $30 shipped.
350TBI injectors ill take $20 picked up/ $25 shipped for them along with the injector pod.
s24adida@yahoo.com
The heads came off of a 1990 Formula 305TPI... I had the heads stripped and hot tanked, they were very low mile heads to begin with so the valve guides didnt need to be cut and for that reason i didnt get a valve job done. The valves are stock and all seals are new. The springs are aftermarket springs that will accomodate cams up to .525" lift. They are PBM springs. The port job was done by my buddy who is a tech at a toyota dealership and builds engines. They are port matched to mr.gasket gaskets and can be bolted on like that or can be polished for a few extra cfm. The only assembly on the heads that need to be completed are the springs on one of the heads (not sure which one) but they need to be installed and come with all the hardware necessary. Also included are the old springs which if you dont want the new springs you can put the stock GM springs on.
The only thing that needs to be done to these heads is to have the new springs on the one head put on along with the rockers. After this has been done these are ready to bolt on.
$200 shipped or $175 picked up.
1997 Lt1 cam, 30k miles in good condition. Has been sitting for a year in my room and I need it gone. Ill take $25picked up/ $30 shipped.
350TBI injectors ill take $20 picked up/ $25 shipped for them along with the injector pod.
s24adida@yahoo.com