Log in

View Full Version : FS: exhaust cutout...NO WELDING REQUIRED!!!

j0n
08-08-2005, 11:54 PM
The perfect toy for all you stock 2.5" exhuast peeps out there...

I bought a 2.5"(stock lt1 i-pipe) cutout and welded a set of slip-fits onto either side allowing me to install the cutout onto my i-pipe by simply cutting a section out and slideing the cutout into place, and securing it with a set of exhuast clamps.

I had it after the cat and it sounded awesome...

yours with one clamp(ya need two but i broke one) for 20 bucks
Savage_Messiah
08-09-2005, 12:56 PM
2.5" is a half inch too small
j0n
08-09-2005, 06:19 PM
i didnt have any trouble puttin it into my i-pipe...and my car had the smae exhaust it rollle doff the assembly line with 10 years ago
PDubs87Z28
08-09-2005, 06:23 PM
pm sent
NJSPEEDER
08-09-2005, 06:59 PM
2.5" is a half inch too small

from the expert on small. :P

later
tim
enRo
08-09-2005, 07:22 PM
2.5" is a half inch too small

from the expert on small. :P

later
tim

:kneeslap:
JPiZZiJP
08-09-2005, 08:38 PM
j0n will this fit my car?
j0n
08-09-2005, 10:08 PM
j0n will this fit my car?

yea

and :lol: at tim lol
Savage_Messiah
08-09-2005, 10:41 PM
ouch :cry: haha
j0n
08-15-2005, 01:13 AM
sold in case anyone cares
bad64chevelle
08-15-2005, 09:07 AM
no one cared, youre just a post whore :lol:
j0n
08-15-2005, 09:09 AM
well....DUH!