Need a shop...

[95formula]

I need to get plugs, wires, and a cap and rotor installed this week and need a good place to do it. I have ngk plugs and talyor wires already but i want a msd cap and rotor. Is their any place open this week that will have the cap and rotor and do an install?

[Squirrel]

summit can get one to ya in a couple days pending theyre still not on backorder...but your ass will get annihilated if you pay a shop to do that stuff, think in the range of easily more than 500 bucks...a couple guys on here will probably volunteer for some food

[Savage_Messiah]

Once gain I'll ask what make sit necessary to take it to a shop?

[95formula]

I'm ok with my mechanical ability, but not too confident. I really don't have the time or a place(rather not do it outside in the cold), i also need to do plugs and wires

...not a whole lot of experiance either

[BigAls87Z28]

Its an LT1? Id help you, but that engine is from the devil

[95formula]

yup LT1, and i know its tuff to work on

[Tru2Chevy]

Go buy headers. Then pretty much anyone here will help you do plugs and wires.

- Justin

[Tsar]

werent there more posts here last night?

[Savage_Messiah]

Tsar you're probbly thinking of the identical thread in the north section...

[79CamaroDiva]

If you don't mind a drive, call up Garfield Auto Center (in Garfield) its exit 61 off of 80. It's not too far from denville, bout a half hour. 973 478 2311. Ask if they can do it this week. Say your friend Melissa told you to call them, they might cut you a decent deal.

If you need directions, ask them or me, its not hard to get to.

[12secondv6]

http://www.njfboa.org/forums/showthread.php?t=14606

[Tsar]

Tsar you're probbly thinking of the identical thread in the north section...
yea i just figured that out...thanks