longtube headers on a 3rd gen camaro

[band77one]

i was told i would have almost no ground clearance? anyone out there with longtubes on a DD let me know if this is true or not ? and would it be worth switchin from hedmann shorty to long tubes

[camaro2you]

haha man come over and look at my car and you will be able to tell:p

[Tru2Chevy]

All depends on the stance of the car and which LTs you get.

- Justin

[Slow Z]

I have Hooker LT's with stock ride height and I've NEVER scrapped them on anything. I drive my car a lot too... speed bumps, potholes, driveways. Nothing scrapes them. I do however scrape the Y-pipe where it runs under the trans crossmember occasionally but nothing bad.

[band77one]

16x8 tires on front and back right now, stock stance on a 88 iroc, but was thinking going 17x9 on the back,with hooker long tubes

[Koll]

IIRC they dont make LTs for 3rd gens. Everything is 5/8. but 3/4 is needed (atleast on mine)

[BobonaStick]

I also had a set of Hooker LT's on my 88 Iroc... The front was lowered 2 1/2" still never scraped... except for the front lip... (expected)

[Slow Z]

IIRC they dont make LTs for 3rd gens. Everything is 5/8. but 3/4 is needed (atleast on mine)

wrong...

Hedman LT's = 1 5/8" with 3" collector
Hooker LT's = 1 3/4" with 3" collector

[Teds89IROC]

:stupid: After my tires, they come next.

~Ted

[Koll]

Yeah I was wrong. But they are $649.00

[Teds89IROC]

For the coated..regular are $409.99 in jegs..and thats for super comps. Worth it in my opinion, they're one of the best headers.

~Ted

[V]

i have a set of painted long tubes, drivers side needs some attention, but pass is nice, $40 for the pair, lol

[icarus402001]

Smokin SS- How much attention does it need and what brand are they?

[V]

i dont know brand,but the drivers side was heated with a torch and bent to clear the clutch slave cylinder on my monte, i ended up going back to shorty headers. and i think one of the tubes were banged in a little for clearence. no rust holes or anything. ill get a pic this weekend.