would this fit my car

[Brando56894]

http://cgi.ebay.com/ebaymotors/98-02-CAMARO-FIREBIRD-TRANS-AM-ALUMINUM-DRIVESHAFT-LS1_W0QQcmdZViewItemQQcategoryZ33738QQitemZ8028309 989QQrdZ1

[Tru2Chevy]

Driveshafts are interchangable from 82-02. It will fit fine, but it will prolly get kinda expensive. Look at the classifieds section on LS1Tech.com for good deals on one....

- Justin

[Brando56894]

ok cool, yea i saw one on LMperformance for about $400 and was liek damn thats expensive then i saw a few of those on ebay for about 100-150

[V]

i bought one off ebay a while back, for 125+shipping. Thats about the going rate. that was for my SS after a gouged a groove in my current one. The new DS has just been sitting around since, and its in mint condition to the point it looks like it was never driven with.(out of an '02 SS) Once i pull my SS drivetrain, I am sending my damaged driveshaft out to be checked and repaired if possible, then selling it, oj throwing it out.

[foff667]

i bought mine for $50 shipped a while back for my Z...there are better deals to be found...ADS aint gonna give you much hp so dont pay much.

[JL8Jeff]

i bought mine for $50 shipped a while back for my Z...there are better deals to be found...ADS aint gonna give you much hp so dont pay much.

Yeah, but the bling factor is way up there! My stock steel driveshaft is covered with rust so it would be nice to swap it out. But I'm not touching it unless I have to.

[Tru2Chevy]

I only paid $50 for mine too.....

- Justin

[Brando56894]

yea i know it wont do that much but hell itll help

[Koll]

well it is less rotational mass..........