PDA

View Full Version : need to recalobrate my speedometer.


My9225thanni.
06-13-2006, 07:43 PM
Those anyone know how to or know someone who can recalobrate my speedometer. I put a new rear in the car and as always the speedometer dosen't read right its like reading 10 15 miles over wat its supposed to read. can anyone help me let me know.

blck81z28
06-13-2006, 08:31 PM
i believe you need to change out the gear in the trans

Tru2Chevy
06-15-2006, 01:53 PM
Yea, you have to swap your speedo gears.

What rear gears did you have, and what gears did you install?

- Justin

My9225thanni.
06-15-2006, 10:54 PM
i swapped entire rear for rear i had a stock rear in my 92 which i guess were something small lower then 3.42s. I put a rear in from an 89 iroc which i beleive has the stock gears which i don't remember what size gears were in it and its a 9 bolt. If u can figure anything out from this let me know i need to get the speedo fixed. Thanks

Tru2Chevy
06-16-2006, 12:11 PM
Well in order to fix the speedo, you will have to know what gears are in your car now.

- Justin

BonzoHansen
06-16-2006, 02:59 PM
Man, I once found a site that had a calculator for this. I'll try to find it again. And somewhere in my great archive is a Super Chevy that shows you how to do it and lists all of the available gears. But neither helps you now.

You need Tire OD, Gear ratio and how many teeth are on the speedo drive gear on the output shaft. Usually you can get by changing the driven gear (the one that comes out).

Man, the 92 still uses a cable? Damn old cars. :)

BonzoHansen
06-16-2006, 03:03 PM
Stop looking, I found it (thanks Google)

http://www.tciauto.com/tech_info/speedo_gears.htm

I was right about what you need to figure it out.

bad64chevelle
06-19-2006, 01:40 PM
Yeah just gotta get the right gears for the speedo. One reason why mine isnt hooked up because it will be like 30 MPH off with those 4:10s.

My9225thanni.
06-19-2006, 02:53 PM
thanks for that website it seems like its going to be very usefull thanks guys now do you know someone who can use this and get my car speedo reading right. Let me know thanks enrico

Tru2Chevy
06-19-2006, 02:54 PM
Yeah just gotta get the right gears for the speedo. One reason why mine isnt hooked up because it will be like 30 MPH off with those 4:10s.

I tried looking and couldn't come up with anything for 4.10s (or 4.09s). I figure they have to be out there somewhere, since there were 4 banger S-10s that came with 4.10s from the factory...

- Justin

bad64chevelle
06-19-2006, 10:10 PM
When Bob Maguire Part store used to be down here in Bordentown (not at the dealership) I was able to get them no problem. But since then they have been a little hard to find. Im just gonna wait till the new trans goes in and do it all at once then.

NJSPEEDER
06-20-2006, 03:13 PM
i got my speedo gears from gmpartsdirect. i got hit pretty good on teh shipping, but it is the only reliable source i could find
teh tci site supplies both tci and GM part numbers, so you shoudl be able to jsut go to your local GM dealership parts counter and order the gears.

Tru2Chevy
06-20-2006, 03:44 PM
Ahh...15 and 45 it is....

Non-NC Residents Total: $18.16 Shipped from GM Parts Direct

- Justin