trashman01
06-13-2006, 10:58 PM
1988 Pontiac Trans AM. 305 tbi, t-5, 3.42 10 bolt
black paint, silver decals, 16" BBS rims, ttops, grey interior, digital dash, trans am windsheild banner, 125K, rims have the polished lip, breaks are only 15K old on the back and maybe 5K on the front, glass ttops, pull down hatch rebuilt, brand new headlight motors, recent heater core
the bad:
windows are a lil slow
ttops leak at the corner
carpet is dirty under the floor mats
hood, front bumper, drivers fender is discolored(still looks good from a distance, esp when all cleaned up)
dent on passenger fender, scracthes on rear 1/4 panel
3" ypipe bangs the floor over hard bumps, but not that bad
could use a tune, but not really needed
performance:
motor rebuilt, punched .030 over
intake manifold, small cam,
3" ypipe, high flow cat, dynomax exhuast(good tone to it)
rear lcas and brackets
panhand bar
open element
accel coil, cap/rotor
mr gasket wires
if more info is need. contact me here or at prostrtracer05@hotmail.com
black paint, silver decals, 16" BBS rims, ttops, grey interior, digital dash, trans am windsheild banner, 125K, rims have the polished lip, breaks are only 15K old on the back and maybe 5K on the front, glass ttops, pull down hatch rebuilt, brand new headlight motors, recent heater core
the bad:
windows are a lil slow
ttops leak at the corner
carpet is dirty under the floor mats
hood, front bumper, drivers fender is discolored(still looks good from a distance, esp when all cleaned up)
dent on passenger fender, scracthes on rear 1/4 panel
3" ypipe bangs the floor over hard bumps, but not that bad
could use a tune, but not really needed
performance:
motor rebuilt, punched .030 over
intake manifold, small cam,
3" ypipe, high flow cat, dynomax exhuast(good tone to it)
rear lcas and brackets
panhand bar
open element
accel coil, cap/rotor
mr gasket wires
if more info is need. contact me here or at prostrtracer05@hotmail.com