the blinkers that wont blink

[maroman88]

so i bought all nice fancy LED exterior lights and they look very nice, only prob is the blinkers dont blink, when you put the signal on the lights just stay steady. i know that LED's use less watts then regular bulbs, could that be a problem? the blinkers blinked VERY slow with the stock bulbs so i figured there was to much strain and LEDs might help. i found the flasher for the hazards, which do work, and the horn relay and the door chime but i cant find anything for the blinkers.

[Ian]

I'm pretty sure the flasher for the hazards is the same one for the blinkers. If not, it should be identical and located very close to the one for the hazards.

[deadtrend1]

try a new flasher. They are only like 5 bucks at the store, so its worth a try. I got like 4 of them laying around. The 4 ways will work seperately from the left and right blinkers.

The flasher is a silver orb looking think with 2 flat connectors in a v pattern. Usually its underneath the drivers side dash closer to the center console then the fuse box.

[Silent Z]

I don't know about on cars but my friend did that on his motorcycle. He had to solder in resistors for each blinker/ led. His blinkers were slow to the point that they just dimmed and brightened.

[qwikz28]

did you check the blinker fluid?

[enRo]

:funny:

Go get an electronic flasher from Autozone for $8.

[maroman88]

LOLOLOL i was guna say "ok guys i was just out of blinker fluid" but ya beat me to it.

i found the flasher for the blinkers, it was WAYYY up there. i swapped it with the hazard flasher and they worked, so i stuck the blinker flasher in the hazard spot and it worked too so its all fixed, thanks guys

[deadtrend1]

yea, my description of what it looked like would be better if i didnt murder my spelling. But like i said, most of the time its underneath near the center of the dash

[maroman88]

well i had the same prblem in my 91Z after puttin the LED's in and i switched the flashers in that car too and it fixed it again....wierdddd