part match help

[WayFast84]

here are my cam specs.
Part Number 12-262-4
Engine 1955-1998 Chevrolet
262ci-400ci
8cyl.
Grind Number CS XE262H-14
Description
Intake Exhaust
Valve Adjustment 0 0
Gross Valve Lift 0.464 0.47
Duration At 0.006 Tappet Lift 262 270
Valve Timing At 0.006
Open Close
Intake 21 61
Exhaust 73 17
These Specs Are For The Cam Installed At 110 Intake CL
Intake Exhaust
Duration At 0.05 218 224
Lobe Lift 0.309 0.313
Lobe Separation 114

On a 305 lg4 with hedman headers/dynomax catback and msd cap rotor and wires..


What intake should I get? I need it to work perfectly no egr..
What gears should I get?
and finally what TC?

Remember the car is going to be a handling car eventually, but will see lots of drag racing two..so I need the parts good for both!!

[1984camaroz28]

What tire size u runing?
max rpm?

i whould say a 3400 stall whould do it and give u room to go bigger in time

[johnjzjz]

here are my cam specs.
Part Number 12-262-4
Engine 1955-1998 Chevrolet
262ci-400ci
8cyl.
Grind Number CS XE262H-14
Description
Intake Exhaust
Valve Adjustment 0 0
Gross Valve Lift 0.464 0.47
Duration At 0.006 Tappet Lift 262 270
Valve Timing At 0.006
Open Close
Intake 21 61
Exhaust 73 17
These Specs Are For The Cam Installed At 110 Intake CL
Intake Exhaust
Duration At 0.05 218 224
Lobe Lift 0.309 0.313
Lobe Separation 114

On a 305 lg4 with hedman headers/dynomax catback and msd cap rotor and wires..


What intake should I get? I need it to work perfectly no egr..
What gears should I get?
and finally what TC?

Remember the car is going to be a handling car eventually, but will see lots of drag racing two..so I need the parts good for both!!

ok a good but on the big side choice -- the cam u bought is a 305 to 350 cu inch -- TPI cam for a motor with an added chip and up grade exhaust is that what u have -- 1300 to 5500 max engine speed ??????? - for a computer controlled 1987 to 1998 flat tappet SBC motor ???/ -- jz

[NJSPEEDER]

the cam will be fine.
while the max engine rpm says 5500, this combo will more likely run out of steam below 5000rpm. you will be fine matt.

[Tru2Chevy]

Do you no longer have the action plus manifold? That would be good. If not, find a edelbrock performer manifold. Shop for a used one, don't pay more than $65-70 for it. I got mine for $50.

- Justin

[WayFast84]

I traded the action plus for a radiater.