Log in

View Full Version : Superam instal pics

Fast92RS
10-23-2006, 12:32 PM
I finally got a hold of a superram intake that I will be putting on the 350 I will be building for my car. For those that have one installed can you please post pics of your set up and some detailed close pictures would be aprrecited.
Thanks
JSPERFORMANCE
10-23-2006, 06:45 PM
this one? Its a customers car from a few months ago
Fast92RS
10-23-2006, 07:02 PM
Thats the one. Any closer pics? Also I have heard that the holly afr is the only one that will fit under this intake.
BonzoHansen
10-23-2006, 07:05 PM
Doesn't Paul (Hardcore) have that setup?
JSPERFORMANCE
10-23-2006, 10:53 PM
the holley regulator is the best one anyways....
Fast92RS
10-24-2006, 07:55 AM
the holley regulator is the best one anyways....
OK I have a BBK one on the stock TPI set up right now and it seems to be pretty good but a pain to adjust, you have to try to squeaze your hands and a small wrench under the plenum to adjust it.
JL8Jeff
10-24-2006, 08:15 AM
I like the Holley Stealth Ram intake but the Superram makes more torque I think.
HardcoreZ28
10-24-2006, 04:37 PM
I have the Super Ram but no close up pics. Ask me any questions you may have since I've had mine on and off about 5 times. Also the Holley AFPR is best since it has the big adjuster knob. I don't think it would be impossible to use another though with too much difficulty. My regulator is pretty easily accessible. Hardest part of the whole install is the runner to plenum bolts....major pain but do it the right way from the bottom up. Any of the alternate methods is just asking for trouble. RTV the runners to the intake along with the gaskets. The plenum gaskets shouldn't need any sealant.
Fast92RS
10-24-2006, 05:22 PM
Ok thanks for the info. As I go along if I come up with an issue I will PM you. The thing I need now is a better intake base.
HardcoreZ28
10-24-2006, 07:24 PM
Get the Edelbrock baseplate and port it out....much more cost effective than the Accel one....atleast last time I checked. Biggest issue you may run into is the clearance between the plenum and the wiper motor if you still run one on your car, especially with poly mounts. Mine just fit in there with a little massaging on the connector for the wiper motor.
Fast92RS
10-24-2006, 07:46 PM
What did you do to the connector? I read somewhere to remove the mounts and replace the motor and it will give you more room.
JerzLT1
10-31-2006, 05:28 PM
i have the accel super ram lower intake on my 86... its getting sold and the new owner will be throwin a carb on it