Rob WS6
11-13-2006, 01:18 PM
-These are ZZ4 aluminum heads off of a ZZ4 crate motor with less than 15k miles. Casting 113, heads are extremely clean and ready to go. Include ZZ4 springs/locks/retainers all still installed. I was going to use these for my personal buildup, but I just picked up an LS1/4L60E yesterday, so Im getting rid of most of my Gen I SBC stuff to finance the swap. $600 firm plus shipping.
-L98 shortblock, mielage unknown, .040 over, will need to be freshened up. 1 piece rear seal, roller block, internal balance. Cylinder walls are good, bottom end still assembled including oil pan and timing cover. No cam or other valvetrain. $200 obo, pickup or delivery only.
-L98 iron heads 083 castings, 40,xxx miles, VERY VERY clean, fully assembled ready to bolt on. Came off an engine/tranny combo I bought just for the shortblock and tranny. $200 obo plus shipping.
-Hooker Supercomp Longtube headers, p/n 2210. They have been beadblasted, and have some light surface rust. Headers are in nice condition except for the previous owner decided to clearance the pass header for a large starter instead of using a mini starter. Can use as is, as the dents cant be seen once installed, or you can fix them. No o2 installed. Either way, a good deal at $200 obo plus shipping ($450 new).
All parts are located in NJ, 08052. Are available for local pickup as well as delivery within reasonable distances. PayPal accpted as well as US Postal Money Orders. Willing to make package deals too. :mrgreen:
-L98 shortblock, mielage unknown, .040 over, will need to be freshened up. 1 piece rear seal, roller block, internal balance. Cylinder walls are good, bottom end still assembled including oil pan and timing cover. No cam or other valvetrain. $200 obo, pickup or delivery only.
-L98 iron heads 083 castings, 40,xxx miles, VERY VERY clean, fully assembled ready to bolt on. Came off an engine/tranny combo I bought just for the shortblock and tranny. $200 obo plus shipping.
-Hooker Supercomp Longtube headers, p/n 2210. They have been beadblasted, and have some light surface rust. Headers are in nice condition except for the previous owner decided to clearance the pass header for a large starter instead of using a mini starter. Can use as is, as the dents cant be seen once installed, or you can fix them. No o2 installed. Either way, a good deal at $200 obo plus shipping ($450 new).
All parts are located in NJ, 08052. Are available for local pickup as well as delivery within reasonable distances. PayPal accpted as well as US Postal Money Orders. Willing to make package deals too. :mrgreen: