Make ten bucks!

[WayFast84]

I need help taking my timing gear off of my crank shaft and putting the new one on including timing chain, I have the puller but I doubt its any good because it doesnt have directions and I stripped my crank where the balancer bolt goes. If you can help me with this, I will give you ten bucks! if You can help me get the short block all together(heads timing cover oil pan and the balancer etc) Ill give you $30

[foff667]

I don't know what to say other than :rofl:

[WayFast84]

I don't know what to say other than :rofl:

teeheeheee

[Tru2Chevy]

If you stripped the crank where the balancer bolt goes, you've gotta get that fixed. Otherwise the crank is junk.....

Also, heads are not part of a short block.

- Justin

[WayFast84]

If you stripped the crank where the balancer bolt goes, you've gotta get that fixed. Otherwise the crank is junk.....

Also, heads are not part of a short block.

- Justin

I know, i said the shortblock all together meaning, its a shortblock now.

how do I get the crank hole fixed?

[Tru2Chevy]

Depends on how bad the threads are....you may be able to just use a tap and die set to clean the threads up (I would advise that you have it done by a professional, or at least someone with plenty of experience).

If they are bad enough, then the crank is prolly junk. You can't exactly helicoil your crank or something like that.

- Justin

[BonzoHansen]

http://www.njfboa.org/forums/showthread.php?t=27266

1 thread is enough...tech posts copied to that thread.