club windshield banner

[nj96z28]

well i just got my club vinyl in the mail. was all excited to put it on.Until i got outside and got the car out of the garage . vinyl is cut straight and the windshield curves :( Ill never ever get it on properly. If anyone has got some skills in this department please gimme a holler as teh last thing i need is more stuff on my shelves that i cant install on my car :( And I know some 1 is gonna go wtf its simple, so heres my disclaimer... i have no patience and i get frustrated extremely easily.I tried 3 different sets of rear bumper inserts and all 3 wound up in the trash can

[NightRydaSS]

You a couple options.

1) you could use a heat gun and curve the banner, but that can mess it up, melt it, ect.

2) chances are the banner is longer then the width of ur windshield. Center the banner on your car, laying it straight. Then cut off the access material on either side. Instead of throwing the material out; use it to fill in the curved opening. Just overlap the material slightly on the banner so when it dries and shrinks you wont get any light in.

[Tru2Chevy]

You a couple options.

1) you could use a heat gun and curve the banner, but that can mess it up, melt it, ect.

2) chances are the banner is longer then the width of ur windshield. Center the banner on your car, laying it straight. Then cut off the access material on either side. Instead of throwing the material out; use it to fill in the curved opening. Just overlap the material slightly on the banner so when it dries and shrinks you wont get any light in.

No, we designed the banners so that they would fit on every F-body 67-02, so they won't be too long for any car. They still fit a 4th gen windshield just fine, you just need to take your time when applying it.

- Justin

[Slo86Bird]

my bro got one for his vette tht was cut straight and we got it to work akmost perfectly, ill post a pic for u when i get a chance.