lt1 head question

[lilredjeep91]

My question is how much would you pay for these lt1 heads. here is the work done to them.

comp valve job
mill .004
back cut valves
cut for seals
pocket work intake exhaust
intake gasket match

[LTb1ow]

Um, is this a backyard job or a professionally done job?

Do you know the casting number?

Not much though...

[lilredjeep91]

the job was professionally done and no i dont know the casting number

[WildBillyT]

Um, bare or assembled? Sounds like assembled- if so, what hardware?

[Pampered-Z]

Find out if they are complete heads (seals, springs etc ) or not. What type/brand vales, and what size valves? If the heads were machined to accept other then stock springs, and flow numbers would be nice too.

Heads could run from around $500 to near $1,500 depending on how much port work and what parts they have in them.


If your investing in heads, I would suggest looking for larger then stock valves. Typically built heads have 2.02 1.60 valves. I also lean towards using 2 double springs (normally require the pockets machined).