Slow Z
06-12-2009, 09:33 AM
Getting bored and looking to start a new project... Willing to sell my entire motor in various configurations
357ci 4-bolt studded mains, Scat 9000 crank, 4340 I-beam rods, SRP forged pistons, Canfield heads, Cam Motion custom solid cam, way too much to list... I'll write out all the detailed specs if there is interest.
$7000 gets you entire motor carb to pan, ignition/electronics and headers
$6000 gets you minus ignition/electronics.
$5500 minus ignition and carb
This is a killer pump gas street motor that is capable of single digits on a small shot. It's 100% streetable and even gets 14mpg in my 3.92 geared TH350 car. Can hear it run, can see it perform... Might even be willing to help buyer install it if you're close enough to me.
http://i42.tinypic.com/15yw45h.jpg
http://i43.tinypic.com/wqwt3a.jpg
357ci 4-bolt studded mains, Scat 9000 crank, 4340 I-beam rods, SRP forged pistons, Canfield heads, Cam Motion custom solid cam, way too much to list... I'll write out all the detailed specs if there is interest.
$7000 gets you entire motor carb to pan, ignition/electronics and headers
$6000 gets you minus ignition/electronics.
$5500 minus ignition and carb
This is a killer pump gas street motor that is capable of single digits on a small shot. It's 100% streetable and even gets 14mpg in my 3.92 geared TH350 car. Can hear it run, can see it perform... Might even be willing to help buyer install it if you're close enough to me.
http://i42.tinypic.com/15yw45h.jpg
http://i43.tinypic.com/wqwt3a.jpg