PDA

View Full Version : Ignition Coil failure. What happened?


TAdan
08-20-2009, 02:02 PM
Hi I have a 1999 T/A, 4l60E, GMPP crate LS6, Spare ECM stock LS6 tune.

A few days ago I was driving in stop and go traffic on a very warm day. The car developed a severe misfire and got very hot, smoke was coming from my catalytic converter. After several minutes the misfire cleared up.

I believe my cats were overheated and ruined due to the misfire.

I scanned the car and came up with the following codes.

P0351: Ignition Coil A Primary/Secondary circuit malfunction
P0353: " C Primary, etc...
P0355: " E Primary, etc...
P0357: " G Primary...

So... any idea what could have caused these four coils to malfunction?

What controls the coils? (ECM or something else?)

The car seems to run O.K. now but it feels like the cats are clogged. (Also how many cats does the car have? I have not been under there in a while.)

Any help or insight would be appreciated! Thanks.

Dan

sweetbmxrider
08-20-2009, 02:28 PM
pcm controls the coils

The following may cause an intermittent condition:
Poor connections
Corrosion
Mis-routed harness
Rubbed through wire insulation
Broken wire Inside the insulation

i'd be looking at grounds and such for those coils. for all of them to throw a code on the same bank leads me to believe its an issue on that side with wiring.

should be 2 cats

Batman
08-23-2009, 01:39 PM
Yeah LS1 coils are very reliable, I'd check grounds and wiring harness