View Full Version : What to do?
LS1ow
09-28-2009, 03:11 PM
ok im shure a lot of you have seen the thread about were my dad crashed my car.
well its been a week so now i need to find what to do with it and were i should be headed in the car world.
the car has almost a fresh (less then yearr old) built 383 stroker LT1 with full bolt ons. And a fully built TH350 w. full manual valve body to go along with it. but the body of the car is done. engine runs fine and trans shifts good.
so i was thinking of things i can do... so far ive though of..
1.swap my drivetrain into another camaro/firebird
2.swap into a C4 vette
3.swap into S10
4.swap into fox body mustang
5.swap into import(240,rx7,gen II supra)
or...
6. sell it/part out and start over new..
maroman88
09-28-2009, 03:38 PM
number 1 would prob be the easiest... i had an S10 with a sbc in it, lotsa fun too, the vette one could get expensive, and the import and mustang ideas are just :gay:
Z28 Heritage
09-28-2009, 03:56 PM
2.swap into a C4 vette
Or
5.swap into import(240,rx7,gen II supra)
blueshark123
09-28-2009, 03:56 PM
I would look into a 240. Probalby the cheapest and as far as weight goes you cant beat it.
LTb1ow
09-28-2009, 04:41 PM
240 or RX7, that would be pretty awesome. Could go pretty fast with no to much moneys.
I know someone with an S10 he is selling.
JW :D
NJ Torque
09-28-2009, 05:52 PM
deff a c4 vette.
MonmouthCtyAntz
09-28-2009, 05:53 PM
id go with another fbod
Czop418
09-28-2009, 06:28 PM
... How much money are you willing spend. Dropping it into a 6 cylinder willl prolly be the cheapest and you would have your z28 for the misc. parts you would need to for the swap.
sweetbmxrider
09-28-2009, 06:42 PM
1 would be most logical
2 is ehhhh
3-4 would be alright
5 my buddy and i were talkin about before, deff some good weight savings but alot of custom work and headaches!
6 is really up to you. market is tough lately though and i doubt you will get half of what you put into it.
blueshark123
09-28-2009, 07:54 PM
1 would be most logical
2 is ehhhh
3-4 would be alright
5 my buddy and i were talkin about before, deff some good weight savings but alot of custom work and headaches!
6 is really up to you. market is tough lately though and i doubt you will get half of what you put into it.
You are incorrect in the custom work and headaches. They sell complete kits for everything to drop these motors into 240s and rx7s. These imports should have came with v8s from the factory. TS, if you want more info on this lmk. I can point you to where you need to get started.
sweetbmxrider
09-28-2009, 08:04 PM
got a link? i'd love to see a direct swap kit cause it doesn't exist. there is more to it than most will tell you and its part of the joy of customizing
wretched73
09-28-2009, 08:28 PM
s10 or f body, orrrr g body if you want to be real cool :)
KirkEvil
09-28-2009, 08:34 PM
swap into an rx7 would be awesome. then again it would be so much easier and cheap to dump it back into a v6
blueshark123
09-28-2009, 10:58 PM
got a link? i'd love to see a direct swap kit cause it doesn't exist. there is more to it than most will tell you and its part of the joy of customizing
http://www.hinsonsupercars.com/
And there are many many more that provide motor mounts, driveshafts, radiators, fuel setup, etc. No customization needed
http://www.hinsonsupercars.com/p-1082-complete-s14-conversion-package.aspx
Im sure it wouldnt take much to get the LT1 to fit with this kit.
Jersey Mike
09-28-2009, 10:59 PM
rx7
ib4200
09-29-2009, 01:15 AM
i would drop it into a 98-02 v6 f body
g body swap would also be cool
OR swap into a 5th gen somehow
CamaroJoe1987
09-29-2009, 08:25 AM
mickey, i would do 1, 2 or 3, i know of the perfect donor car for the C4 if u want to bad enough
LTb1ow
09-29-2009, 08:56 AM
Or a nice third gen roller. Prob cheaper than a 4th gen.
The Fixer
09-29-2009, 09:56 AM
Or a nice third gen roller. Prob cheaper than a 4th gen.
Indeed, buy Justin's 3rd-gen! Or a G-body with that drivetrain would be cool, like a mid-'80s Cutlass or Grand Prix since they're even cheaper to find than Montes.
Savage_Messiah
09-29-2009, 11:47 AM
OR swap into a 5th gen somehow
sorry but... from me, this gets the biggest HELL ****ING NO
WildBillyT
09-29-2009, 03:10 PM
sorry but... from me, this gets the biggest HELL ****ING NO
Yeah, really. People would look at it with disgust. That'd be like swapping a TPI into an LS1 car.
sekret agent
09-29-2009, 05:28 PM
one of my friends has an s10 set up pretty much just like that and its a pretty fun car.
LTb1ow
09-29-2009, 05:34 PM
Yeah, really. People would look at it with disgust. That'd be like swapping a TPI into an LS1 car.
If I had the money oh the things I would do... LT1 into LS1 :nod: Or into a 5th gen. LOL
MonmouthCtyAntz
09-29-2009, 05:35 PM
sorry but... from me, this gets the biggest HELL ****ING NO
Id have to agree....
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.