Edelbrock TBI intake bored and ported for 2" TBI NEW - SOLD

[79camaro]

Up for grabs I have a edelbrock TBI intake pn 3704 I believe. It was used for dyno/engine break-in only, so it is basically brand new. It has been gasket matched and bored to accept either a stock or 2" holley aftermarket TBI unit. On a very mild 350, this intake made a best pull of 348hp and 356lbs tq(but the customer opted for a 4 barrel setup that made less tq- go figure), all with a very mild lunati 60101 cam kit and sr world factory replacement heads along with 9.2:1 compression. This is a perfect upgrade for any TBI truck or F-body. All machine work was done by daimond machine in Texas.

Asking $200 Firm or interesting trades

http://i5.photobucket.com/albums/y175/79camaro/tbiintake.jpg

[79camaro]

TTT....Come on TBI crowd, anyone looking to make nice street TBI power? Im also open to trades.

[79camaro]

bump8-)

[79camaro]

sold on ebay