Log in

View Full Version : Video from Atco 9/29

BarneyMobile
10-03-2009, 12:01 PM
Here some video from tuesday night at atco (9/29) Still workin on the driver mod:lol:
No bottle for now!
http://www.youtube.com/watch?v=PypHxbhyB5w&feature=channel
NjbadSS
10-03-2009, 01:52 PM
nice runs! seem very consistent
BarneyMobile
10-03-2009, 02:16 PM
on the 2nd to last run, I missed 3rd:banghead:.
NJ Torque
10-03-2009, 02:55 PM
Looks like it leaves hard, Rob.

You have a two step?
JerzLT1
10-03-2009, 06:09 PM
Looks like it leaves hard, Rob.

You have a two step?
he likes to call it his rev limiter lol
BarneyMobile
10-03-2009, 06:10 PM
Looks like it leaves hard, Rob.

You have a two step?
As Ron would say, "its the factory 2 step" aka revlimiter:twisted:
Tru2Chevy
10-03-2009, 07:01 PM
Looks good Rob!

- Justin
98tadriver
10-04-2009, 08:57 AM
nice runs! especially that last pass. the 2-3 and 3-4 shifts sounded realllly good. that wouldve been your 11.33 pass in better air! lol
BarneyMobile
10-05-2009, 02:03 PM
nice runs! especially that last pass. the 2-3 and 3-4 shifts sounded realllly good. that wouldve been your 11.33 pass in better air! lol
Thanks, Hopefully next time out I can get some nice negative DA to run in!:nod:
blueshark123
10-06-2009, 12:12 AM
Very nice runs. What were your 60 foots like and what are your mods?
98tadriver
10-06-2009, 04:26 PM
his 60's are shown on the board after his launch, theyre all in the low-mid 1.6's :) he's H/C/I and full bolt ons with a 9inch under the car 3.89 gears i believe?
bubba428
10-06-2009, 04:53 PM
yo....I wanna go race so bad...I'm about to say F, this and just toss a set of 4.10s in the ten bolt weld the spiders and pray