Log in

View Full Version : Corvette C5 Wheels


Wolfblitz
02-12-2010, 06:55 AM
I got lucky and got a set of C5 wheels and tires for free. Was going to put them on my 99 Firebird. Specs are Front = 17" x 8.5" Rear= 18" x 9.5". Should that be fine for clearance or will i have to start bending things back on a stock suspension? And if so, any ideas how?

MonmouthCtyAntz
02-12-2010, 07:17 AM
Might need a big hammer and make some room for yourself.

ar0ck
02-12-2010, 08:20 AM
Might need a big hammer and make some room for yourself.

He'll be fine with 9.5" rears.

You'll be fine, just slap them on and drive on off into the sunset.

creeper
02-12-2010, 08:34 AM
if they're y2k's you might have to do a little hammering. they're not very wide but the offset(63mm) causes them to sit "in" a little further than most other wheels. mine would rub a tiny bit when making hard turns, and my rear is probably closer to centered than stock.

lots of people run 1/2" spacers in the front and 1" in the rear so they don't tuck as much, but i didn't think they looked bad just bolting them up.

maroman88
02-12-2010, 08:42 AM
i had wagon wheels on my 95 Z28 and the rear needed the BFH mod

NjbadSS
02-12-2010, 11:39 AM
They should be fine...I had 18 inch Z06 rims on my Z28, 295 tires, and they fit with no mods

LTb1ow
02-12-2010, 11:40 AM
Be prepared for the rake.

ar0ck
02-12-2010, 11:52 AM
Be prepared for the rake.

What rake?

Wolfblitz
02-12-2010, 03:32 PM
Slow-V6 has them on his car, and he had to use the BFH mod lol. They look great though.

B4C
02-12-2010, 11:27 PM
Dude when are we picking these up from Joe...I haz BFH too for the "mod"

NastyEllEssWon
02-13-2010, 05:54 AM
best way to find out is to put em on and check. its not really a waste of money cause plenty of people have gotten vette wheels to work without a problem. the wheels on my t/a were 11'' wide too and they fit without any hammering, but again the offset is where that comes into play.






Yesterday 12:40 PM
LTs1ow Be prepared for the rake.





rake!

Slow-V6
02-13-2010, 02:47 PM
Just a little banging was needed on my car. All I really needed was a little spacer but I thought it would be safer without the spacer. The fronts fit fine just the backs needed a little banging.

Did homeboy with the C5R finnally get new rims?

Wolfblitz
02-16-2010, 09:05 AM
Yea, think he ordered the carbon fiber ones. He just needs tires now, then i can go pick up all his old ones, both sets lol