8.5 MM wires (fitment into clips) LT1

[drmrman]

I have seen this come up into discussion before but I have never seen a resolution other then drilling out the stock plug wire stand off clips. Does anyone make them aftermarket to fit larger MM wires!?

1993 LT1 vette

Thanks!!!

[sweetbmxrider]

http://www.made4uproducts.com/wire_looms.htm

guys that sell lt1 over the valve cover wire kits use the 7-8mm brackets for msd 8.5mm wires. i have a set sitting unopened in my room. if i think of it later, i'll test it out for you.

[deadtrend1]

http://www.made4uproducts.com/wire_looms.htm

guys that sell lt1 over the valve cover wire kits use the 7-8mm brackets for msd 8.5mm wires. i have a set sitting unopened in my room. if i think of it later, i'll test it out for you.

If vette exhaust manifolds are anything like the fbody ones, I would advise against OTVC plug wires.

[sweetbmxrider]

oh i wasn't suggesting getting an otvc kit, i just meant the brackets they use are for 7-8mm wires but the msd 8.5's will fit. they have just standard loom brackets too.

[drmrman]

Thanks guys!