installed my roll bar

[sweetbmxrider]

do you guys think it will pass tech?

link (http://www.ls1tech.com/forums/attachments/drag-racing-tech/227508d1271478793-installing-my-wolfe-6pt-next-sat-install-questions-update-pvc-3b.jpg)

[LTb1ow]

Fail.

You can't drive stick anyways.

[r0nin89]

You probably should use pcv glue instead of just slip fitting the pipes... I mean come on man common sense.

[deadtrend1]

It should pass tech if you used proper purple primer, and plumbers glue.

[sweetbmxrider]

you think tech will fail me when i stall 7 times?


glue is a good idea, do they make a purple glue i could put all over the bars? for strength plus that bling factor!

[baddest434]

good work adam! nice and clean too. you be da man!!!!!!!!!!!!!!!

[sweetbmxrider]

i could make one for your slow whip. its white so it will match better and probably gain some ponies up top!

[NJ346]

adam, you fail. Poser...taking credit for work you didn't do!


http://www.ls1tech.com/forums/13199527-post5.html

[sweetbmxrider]

damn it! get out of here!!!!!!!! you ruin my fun :(

[NJ346]

damn it! get out of here!!!!!!!! you ruin my fun :(

it might have something to do with the link you posted and noticing that the link came from a thread on ls1tech:-?

and if I didn't post it up you know nick would have anyway:wink:

[Anti_Rice_Guy]

and if I didn't post it up you know nick would have anyway:wink:

:shifty:

[SteveR]

As long as you fill the tubes with sand you should be good.

[sweetbmxrider]

haha i was going to rehost it in my photobucket but just didn't care that much.

:lol: sand is a great option!

[JerzLT1]

why would you stall? just hold the throttle down and let your foot slide off of the clutch ;)

[sweetbmxrider]

so easy, a jersey shore man could do it?

[LTb1ow]

No.