quick question

[LS1ow]

on my phone so searchin is a b**tch so i just made a thread

what backspacing/what not is needed on weld wheels(big n' littles) for 4th gen camaros with stock rear/stock suspention. also what modding is needed to be done to clear the brakes?

sorry for the lack of search.

[Mike]

which welds

[LS1ow]

prostars. wouldnt they be the same with every wheel?

[Mike]

no, some have subtle enough differences that they require less or no mods to the calipers...

mine are 15x3 front with a spacer, and 15x8 with -5.5 backspacing in the rear, i had to take a bunch of metal off my calipers. if you get the 15x10s, its a -7.5 backspace, and i dont know about the brakes

[deadtrend1]

Mike is right. 5/16" spacer was used up front. I will reccomend longer studs if you get weld wheels cause the stock ones will barely stick out past the face of the wheel, basically only about the thinkness of the washer.

my rear brakes after grinding, LT1 brakes werent nearly as bad ...

http://i140.photobucket.com/albums/r34/deadtrend1/misc/100_0816.jpg

[LTb1ow]

Weld Pro star 15x8 4.5 back space
part #96-58208

Are those the ones you are looking at?

Nevermind, you wanted to get ford wheels. lulz.

[sweetbmxrider]

15 x 10's need 7.5 backspacing on stock rears and I can't think of other useful info.

[LS1ow]

Weld Pro star 15x8 4.5 back space
part #96-58208

Are those the ones you are looking at?

Nevermind, you wanted to get ford wheels. lulz.

pal is right. turns out they were ford pattern. fml. oh well, onto smallblockposse to find some !