frankmurphy
10-23-2011, 09:30 PM
Parting out my 90 formula racecar project, keeping my motor, fuel system, radiator and gauges. Most of these parts have less then 1k on them unless otherwise stated!
Bmr tubular k-member (KM008H) - $400
Bmr tubular control arms (AA008H) $300
Lakewood 90/10 front struts - $120 for the pair
Lakewood 50/50 rear shocks - $60 for the pair
s10 Manual steering box with pitman arm - $80
Comp Engineering weld on SFC (never installed, slight surface rust) - $50
Borg Warner WC T-5 (8k on the rebuild) - $250
Centerforce Dual Friction clutch kit(250 miles on it tops)(DF161056) -$200
Centerforce Flywheel (700175)(for use with external balance 1-pc rear seal motor)(250 miles as well) -$375
CSR Mini starter(100PSBP)- $250
Custom Built DANA 60 rear(4.11's, posi, complete from drum-drum, new e-brake cables, DIRECT BOLT-IN! ZERO MILES!) -$1400
Hooker Super Comp headers (2210HKR)(fibreglass heat wrapped)-$400
Mufflex y-pipe(welded not clamped)-$200
Mufflex 4" y-pipe back exhaust with spintech muffler, single tailpipe- $400
Either reply here, or email me at franksmurph@msn.com thanks!
Bmr tubular k-member (KM008H) - $400
Bmr tubular control arms (AA008H) $300
Lakewood 90/10 front struts - $120 for the pair
Lakewood 50/50 rear shocks - $60 for the pair
s10 Manual steering box with pitman arm - $80
Comp Engineering weld on SFC (never installed, slight surface rust) - $50
Borg Warner WC T-5 (8k on the rebuild) - $250
Centerforce Dual Friction clutch kit(250 miles on it tops)(DF161056) -$200
Centerforce Flywheel (700175)(for use with external balance 1-pc rear seal motor)(250 miles as well) -$375
CSR Mini starter(100PSBP)- $250
Custom Built DANA 60 rear(4.11's, posi, complete from drum-drum, new e-brake cables, DIRECT BOLT-IN! ZERO MILES!) -$1400
Hooker Super Comp headers (2210HKR)(fibreglass heat wrapped)-$400
Mufflex y-pipe(welded not clamped)-$200
Mufflex 4" y-pipe back exhaust with spintech muffler, single tailpipe- $400
Either reply here, or email me at franksmurph@msn.com thanks!