Which intake manifold for a 350 swap.

[TAdan]

Hi, I am looking at swapping a GM Goodwrench 350 longblock p/n 10076353 into my 84 T/A to replace the stock 305 (LG4).

I plan on reusing my stock ccQ-Jet, aircleaner & factory cowl induction, and EGR setup.

My LG4 intake was warped in the past and the water neck bolts have been helicoiled, so it would be best to go for a new intake.

I plan on running a fairly mild set up so I am just looking for something that can directly replace my LG4 intake and keep the stock hood clearances.

I am looking at the GMPP ZZ4 (#10185063) intake manifold and the Edelbrock Performer (#3701). Will these two give the me OEM clearances i am looking for?

Thanks for any assistance.

[NHRABill]

It has been a LONG while since since I had my 87 bird but when I swapped a 350 in and wanted to keep the stock hood I used a Wieand Stealth manifold with edelbrock carb and topped it with a edelbrock pro-flo air cleaner otherwise it wouldn't clear. I like the stealth because at the time my mild 350 was running a 272 cam, flat top pistons and a 64c head and the rpm power range was low.

This is just my opinion of course and it was a long time ago there maybe better options now.

[WildBillyT]

Gmpps manifolds are made by edelbrock iirc, just with a bowtie casting mark.

[TAdan]

Well I asked this question on Edelbrocks Facebook page and received the following reply:

"If there is any difference in height it will be minimal within 1/4"."

So I think I should be OK going with the Performer...

Unfortunately I only have about 1/4-1/2" to play with before my aircleaner will hit my the bottom of my Strut tower bar... So I guess I'll still need to track down those dimensions. D'oh!

[zraffz]

I never had any issues running any performer/torquer manifolds on 3rd gens. Only issues I ran into was with air gaps and single planes like the victor jr.

[Lt1_8U]

If its a minimal amount, would it hurt to shave the bottom of the strut tower to give you a hair of room if need be. Or shim where the bar mounts with a washer

[TAdan]

Thanks for the feedback everyone, I think I'll go with an OEM LG4 or L69 manifold rather than risk any interference. The STB just makes such a nice difference in handling that I'd hate to have to get rid of it.

LT1 8U, the STB has already been trimmed a bit to clear the air cleaner and if I went any higher it would be hitting the hood.

[WildBillyT]

I take it that you are using a drop base air cleaner already?

[TAdan]

I take it that you are using a drop base air cleaner already?

I am currently using the stock aircleaner. A drop base aircleaner would solve my problem... but, since i'm nuts I'll be keeping the stock factory aircleaner as I like the original look. :facepalm:

[WildBillyT]

Get the aftermarket intake and mill the carb pad if it's too much?

[Paul Huryk]

Performer should fit - had one on my camaro until i went with the RPM version (with a taller hood).

[TAdan]

I e-mailed both Edelbrock and Summitt about their intakes. According to Edelbrock the Performer should be within 1/4" of an inch of the stock intake manifold height. Summitt says that their SUM-226008 is exactly the same dimensions as OEM, so I think I'll give the Summit intake a try. Thanks for all the feedback everyone.