Log in

View Full Version : Question on interior conversion

camarocrazy42
10-12-2012, 01:06 PM
what do i need to do to install 4th gen seats in my 1989 camaro? any modifications or is it just bolt in and go
Mike
10-12-2012, 01:13 PM
They bolt right in. May have to do some work for the power seats to operate if you don't have them now
V
10-12-2012, 02:12 PM
This shouldn't apply in your case, but for future references...

In 3rd gen cars that have split rear set backs(mainly trans am/firebird), In order to install a 4th gen rear seat back, you need to cut off the center pivot point thats on the transmission tunnel between the 2 rear seat bottoms.
maroman88
10-12-2012, 04:12 PM
lil 3rd gen 101
1320B4U
10-12-2012, 09:10 PM
Bolt in and enjoy...look for bird seats though..esp in leather, they look better.
greenformula92
10-18-2012, 08:34 AM
Bolt in and enjoy...look for bird seats though..esp in leather, they look better.

More comfy too
WSex
10-18-2012, 10:20 AM
i have 4th gen rears in gray for sale.
if interested
BonzoHansen
10-18-2012, 12:53 PM
This shouldn't apply in your case, but for future references...

In 3rd gen cars that have split rear set backs(mainly trans am/firebird), In order to install a 4th gen rear seat back, you need to cut off the center pivot point thats on the transmission tunnel between the 2 rear seat bottoms.

iirc that is just a plate spot welded to the floor. I remember adding that to my 82 when i changed the interior over to one from a later car.