Carb Spacer Plate

[LTb1ow]

Looking for ~ 1/2 inch one, lemme know if you have one

Vic E Intake

[WildBillyT]

4150 flange. Right?

[S.J.SLEEPER]

make one? I think I have some 1/2" aluminum t6 sheet

[LTb1ow]

4150 flange. Right?

I have no idea :rofl: Its a square thingy thats not a stock LT1 intake.

make one? I think I have some 1/2" aluminum t6 sheet

I may, making a plug for the opti at work, may just make one on the mill.

[wretched73]

4 hole? single hole? What type of material? There is a whole lot of info about benefits of material types.

[V]

4 hole? single hole? What type of material? There is a whole lot of info about benefits of material types.

I'm gonna guess he's looking for a larger single opening plate. And not too picky about material.

I may have one, I'll look around tomorrow.

[LTb1ow]

Yea large opening, and material doesn't matter, EFI.

[V]

I tried looking today but a near avalanche prevented me from proceeding further into my quest. It will take me a few days to excavate properly and search the location I last remember it being in.

[Featherburner]

Just go old school and use a piece of plywood!

[LTb1ow]

Wood is cheesy and its a pain to mill. Was thinking about a piece of garolite..GME/GMG etc. But, still cheesy and in the end, cost more to make than for me to buy one :lol: