T56 swap

[Lt1_8U]

Hey guys, I'm putting a t56 on a two piece rear main seal engine. I know I need a special flywheel and they are pricey. I found this company that makes the same flywheel for a lot less. Has anyone used them before?

http://americanpowertrain.com/i-8425817-153t-billet-steel-conversion-flywheel-for-use-with-lt1-t56-pull-style-clutch-2-piece-crank-seal-1-700-depth-neutral-balance-153t.html

[Featherburner]

Check out SPEC http://www.specclutch.com/conversion_combos/view/2

[WildBillyT]

I have. They are legit. Only ones who make the to bearing collar.

[Lt1_8U]

Thanks for the site! And the feedback. Ill see how much shipping is for both and compare price. They both should be good quality so ill just try to get a good price.

[Jersyboyy]

Hey I have a flywheel i have the centerforce once. Im doing the SAME SWAP, but my engine is EXTERNALLY BALANCED (383 with 400 style crank). This flywheel is for INTERNALLY balanced motors (standard 350 327 305). Its barely used and just has surface rust on it local machine shop wants 40 to resurface like new. Its a $500 flywheel and iv was about to post it for sale all over the place but ill give ya first dibs if ya want.
Pm me if your motor is internally balanced and your interested well talk price.