November Car of the Month Submissions

[BonzoHansen]

Anyone can post one photograph of only their Camaro or Firebird in this thread. Photographs of multiple cars or cars with models will not be accepted.

Please include your real name and a short paragraph (at least a few sentences) describing the car as well.

If this is not posted in this thread by the time voting begins, your car will not be included in the vote.

All submitted pictures should be a minimum size of 640 x 480, as this is the size of the image that will be posted on the home page. If you aren't sure of the size, post it up the largest image you have (within reason), or send a private message to me for assistance.

At the last week of the month we will post a poll that will last for one week and the winner will get to spend the following month showcased on the home page of the site. Past winning cars (regardless of ownership changes) will not be eligible to enter again for 12 months.

Any pic considered poor quality by staff (blurry, cell phone, etc) will be ignored in COTM voting.

Please limit this thread to posts submitting pictures only. Comments and other chit-chat will be removed and offending users will be penalized.

GET THOSE SUBMISSIONS IN!!!

[Fast92RS]

http://i1332.photobucket.com/albums/w608/Derekff42/ZL1/2013-10-04145302_zps56fe4d3b.jpg

Derek Kraese
This is my 2013 Camaro ZL1 that i purchased in September. So far I have added a roto-fab cai, ported throttle body, apex catch can, roto-fab heat exchanger reservoir, ati balancer and 5% overdrive pulley.

[omarcamaro]

my 95 z28 my wife purchased this car for herself in 2003 drove it in the rain a little to aggressive. she came home and told me I had to go buy her another car it went side ways on her. I have upgraded every part of this car since then. I built a 383 for it proformabuilt level 3 trans strange s60 rear lower kit oem ss hood custom ss style rear wing, among a lot of other mods

[ThoR294]

Brandon's 96WS6

http://i.imgur.com/x4579iq.jpg

I bought this car in 2006 just before I graduated Automotive Training Center. I have a lot of memories with his car, a few scares, and fun times. I have had a rear u-joint explode and deploy my airbags, I had a lady run over the front end of my car in a parking lot with a jeep (she parked next to me, and said the white paint on my hood and black paint on her rear bumper was always there), a blown stage 2 clutch that put the car down for 2+ years thanks to unemployment, a wicked vibration that made me scared to drive the car (Pinion Angle Issue) and a tree falling on it from Sandy. The car is now FINALLY back on the road (after about a $2000 parts list: clutch, flywheel, opti, water pump, both window motors/regulators, LS1 front brakes, rear brakes, plug wires, A/C Compressor, fuel pump that died after i installed the clutch...)

Right now, I am planning on getting LT headers/Y-Pipe/Tune and a paint job to repair the damage that bitch Sandy did... Also fine tuning my driveline angle to get rid of the vibration COMPLETELY.

Mod list:
GMMG Catback, TPIS Air Foil, SPEC Stage 1 Clutch, Strut Tower Brace, BMR Subframe Connectors, BMR LCAs, Deleted TB Coolant, 3.73s, Koni 4/4s, Strano Springs, UMI Adj. Torque Arm, UMI Relocation X-member, UMI Adj. Panhard Bar, MGW Shifter, LS1 Front Brakes, BLS Headlights, Clear corners, 10 powerbass speakers and a 10" powerbass sub in a stealth box...

Sandy Damage (https://fbcdn-sphotos-h-a.akamaihd.net/hphotos-ak-prn1/615771_10151322953763072_1948200051_o.jpg)