trans oil cooler line

[beaver50]

I have a 94 Z28 it has the 4l60e trans.I have a hose leaking,its the top at the radiator and it goes into the bottom at the case.I found a hose at rock auto but it starts at the radiator metal.Then it turns into rubber and goes back to the case.Is this the right one?if so can I still use the brass fitting or do I need to get another one?

[V]

what is the part you call the case?

[sweetbmxrider]

Yes, the stock trans cooler lines are a hard line to rubber back to hardline from the radiator to the transmission. Post pics of yours so we can verify its the stock setup.

[beaver50]

I call the case the the transmission case.I finally got it straight.The part that come in was just from the radiator to about 2 foot.the you have buid the rest your self.They dont make the whole line.So im getting it made up now.i should have it on this evening.

[beaver50]

Has anybody done this.Mad there own transmission cooler lines.Mine is leaking right at the fitting.the fitting that goes on the brass fitting.So do you think I can cut a small peace out.Put a peace of transmission dooler line hose put a new fillting on it and clamp it all up?

[sweetbmxrider]

Hose clamps won't hold. You can use braided AN line or pushlok sold by summit and jegs.

[beaver50]

Thanks for getting back to me.And Thanks for the info ill get on there sites and get stuff ordered up.

[Dudbird113]

Hose clamps held mine but the ends were flared to keep it from popping off.

[beaver50]

I think I might try it.Its just the fitting thats bad.Maybe if I use a barbed fitting it might work.I hope anyways.

[Dudbird113]

Barb fitting and a hose clamp. She good