exhaust tubing and bends

[redsoxsstink]

so i bought myself a welder and have some determination. i want to weld up an exhaust for my third gen. my y pipe is in good condition, i have a borla XR1 i want to run where the cat is normally. then i just need tubing from there to the axle where it will connect into the back half of a SLP loudmouth catback.

what i need is some tubing.. about 3ft of 3in strait tubing and 2 3in 45* bends, not sure where to get them from would prefer local as i want to take a stab at it this weekend.

i would think NAPA would be where i want to go but their website is useless for searching. autozone and advanced both seem to not have what i want/need and pep boys is in the same boat as napa with a shoddy search engine.

so what suggestions do you have? doesnt need to be stainless either.

[sweetbmxrider]

Summit with fast shipping!

[BonzoHansen]

if you have a local place that caters to trucks and buses they might have it. Back in the day before 3" pipe became normal i had to get it at coast cities bus in Neptune.

[Dudbird113]

Order from jegs, free shipping regardless and it usually takes 2 days to 3 days max since there by ohio i think?

[NJSPEEDER]

Talk to Paul at CTW, ---->>>>

CTW sells a few brands of exhaust products, including Flowmaster. He can easily match your needs.