14x1.5 fitting

[Whoboy580]

Anyone know where I can get a fitting for the 14x1.5 brake fitting or parts to build a fitting. I need to go from 14x1.5 Thread, Bubble flair,male to 1/8 npt female. I have tried a lot of places, and search the internet for hours with no luck. The one place that I found a fitting I bought and it is the right thread but not long enough and everywhere I go or call cant help. Here what I am connecting too.

http://cimg9.ibsrv.net/gimg/www.thirdgen.org-vbulletin/640x480/80-img_2675_1302ec7bdeeaad2ba574c65c39f0385f3f55ada6. jpg


http://cimg8.ibsrv.net/gimg/www.thirdgen.org-vbulletin/640x480/80-img_2674_de980b1734dce79620431739a55867ebc6dc0384. jpg


http://cimg7.ibsrv.net/gimg/www.thirdgen.org-vbulletin/640x480/80-img_2672_f07c815aca4d8dc2c0d7f780c1e440e0dee01a03. jpg


http://cimg6.ibsrv.net/gimg/www.thirdgen.org-vbulletin/640x480/80-img_2670_e35fe794785513dc855f17aa2a996d634b64d3dc. jpg


http://cimg5.ibsrv.net/gimg/www.thirdgen.org-vbulletin/640x480/80-img_2669_82edb07804802a6a372ffff2de63b9cc9c9ce55d. jpg

[//<86TA>\\]

Is there enough meat in the fitting to drill and tap it to 1/8npt on the inside? If so I know where to get unions for that size, so with a union and another 14mm fitting you could end up with a 1/8-27 female thread

[//<86TA>\\]

Ok I looked at my car.
I assume you are installing an adjustable prop valve?
I used a union, another 14.5mm fitting with a short flared piece in it to make a seal, then drilled and tapped the fitting and installed a heavy wall steel 1/8 pipe nipple between the fitting and the prop vavle.

I know it sounds a tiny bit ghetto, but it the only 'bolt on' way to do thus I have ever found outside of a custom machined fitting. Its been on my car for probably 10 years now with no problems

[Whoboy580]

can you post pics please

[sweetbmxrider]

Why not just cut it off and flair it to what you need?

[//<86TA>\\]

Stainless, not easy to flare without a very expensive flare tool

[sweetbmxrider]

True, I am spoiled with my hydraulic flaring tool!