FS: 1987 Camaro Z28 LS swap $4500

[BigAls87Z28]

Yeah, it's time.

1987 Camaro Z28 with LS swap.

Needs stuff to make it 100% but has a lot of really nice parts.

$4500 obo takes it. Doesn't run, so bring a trailer.

Email me bigals939c1@gmail.com with more question.

[LTb1ow]

Any pictures of the car? Does it start up? Where is it located?

thanks!

[zraffz]

Any pictures of the car? Does it start up? Where is it located?

thanks!

I imagine if it doesn't run, it doesn't start.

[Featherburner]

Hard top or T-top car? Manual or automatic? Any rust? How many miles on the Body? How many miles on the LS? Pictures?

[V]

is the swap mostly finished? custom or purchased harness? which swap components? headers or manifolds? tubular k?

[KirkEvil]

Sweet Jesus.

LS1
Torquer v2 cam 232/234 112 LSA
Single pac v springs
longtube ls1 swap headers
some ls1 swap harness
4l60e
yank 3600 converter
10 bolt rear
4th gen tank conversion, vette filter/reg

Unsure, but think it has 243 heads, efans, walbro 255, ls6 intake and stock ls1 TB. Tune sucks but could be peddled for basic movement around a parking lot.

Needs exhaust from headers to catback, torque arm and mount, new tires, brakes are questionable, wiring help to gauges, a battery, and probably needs all fluids changed before starting up again.

[Jersey Mike]

Sweet Jesus.

LS1
Torquer v2 cam 232/234 112 LSA
Single pac v springs
longtube ls1 swap headers
some ls1 swap harness
4l60e
yank 3600 converter
10 bolt rear
4th gen tank conversion, vette filter/reg

Unsure, but think it has 243 heads, efans, walbro 255, ls6 intake and stock ls1 TB. Tune sucks but could be peddled for basic movement around a parking lot.

Needs exhaust from headers to catback, torque arm and mount, new tires, brakes are questionable, wiring help to gauges, a battery, and probably needs all fluids changed before starting up again.

Thanks. To clarify, you don't have an ownership stake in this, correct?

[KirkEvil]

Thanks. To clarify, you don't have an ownership stake in this, correct?

Correct. But doubt Al even remembers what's in it. I looked at finishing the exhaust and TA mount about 2yrs ago, and was probably the last one to drive it then around pal performance, LLC

[Jersey Mike]

Got it. Had a feeling but wasn't sure, what with all the wrench time. So to all prospective buyers, all negotiations should go through Al.

[LTb1ow]

Got it. Had a feeling but wasn't sure, what with all the wrench time. So to all prospective buyers, all negotiations should go through Al.

May be tough to get in contact with him.

:bertstare:

[BigAls87Z28]

If there as only an email address posted in the original post....

Anyway, mostly what Taylor said, but it's a 9 bolt, OE third gen tank is still in but with the 255 pump

Harness is custom made by Speartech, Stainless Steel Works/Hawks LTs

Ttop car, auto.

Any questions, please email.