thanks for your help JR1 well let you know how we make out.

Thanks JR1, we have moroso upper and lower motor mounts on it. I am thinking its an outter tie rod. I will likely replace them with edquay rod end tie rods to get rid of the toe in while the front end is up. Are your lca's chrmo or mild steel? I see that the lower mounts are mig welded on to it. I planned on doing it the same as you have it. How much droop should i look for when i weld the upper tabs up? Im going to do the limiters and try launching at a lower rpm around 3500 and see how it goes. After i get it straightened out ill pull the limiters and turn the launch rpm back up and let her fly again for some photos.

JR1, front end limiters worked out great. 1.31 60' foot & 1/2 off almost to the 60' mark.

to make this thread less sucky heres some vid of your car doing a wheelstand

http://www.thevettedoctors.com/video...wheelstand.wmv








oops nm thats the 7 second vette doing one hehe

bawaaaaaa i have been hoping that maybe someone there happened to get it on video and post it.
when i read the post i got wood:mrgreen: then limp in a sec, lol btw ours was better then that imo

Well,if i had a video of the wheelstand from last year, i had the car straight up bumper scraping till the end of the consession stand at Island Dragway, ask anyone there, its true. its sucks when everybody wants to watch me go instead of taping it.

Plus now i'm going to tape every run, now i got a video camera inside the car.

If anyone needs a video camera mount for inside your car, (www.ioportraing.com). JR1.