Quote:
|
Quote:
Quote:
Quote:
|
Quote:
|
Since the $500 subaru is fixed... my spot in the garage is back open, and the bird is getting love again.
https://i.imgur.com/L3QF1rbl.png Measured distance between the tailshaft housing and rear. 44.5" inches. Called PST and they set me up with a driveshaft. Going to remove my Y-pipe and order the kooks catted y-pipe from WS6 store too. maybe I can finally daily drive this thing! |
Fedex man brought something nice yesterday
https://i.imgur.com/WNtQFIrl.jpg Out with the old... https://i.imgur.com/KvJQaCDl.jpg In with the new! https://i.imgur.com/aSYRP44l.jpg Vibration is much less. Still feel it on decel, probably from stupid ass y-pipe. Jersey Mike has a TSP Y he is willing to part with so ill try that first |
Not much has been done. Replaced belt tensioner since it was squealing a bit. fresh inspection. oil change... Y pipe sitting in garage gotta install it, i really hope it fixes the vibration.
|
Car is currently at ProFab Chassis investigating the dreaded vibration. They noticed the motor mounts were shot, and that the exhaust is pretty much on the k member lol. They also said the panhard wasn't adjusted properly. They are going to do mounts, replace Y-pipe (merge sucks so i want a different one anyway), and center rear, then go from there.
|
motor mounts and fix the exhaust you say? hmm......
|
so if its fixed your racing it, right?
|
Quote:
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Quote:
Quote:
|
Quote:
|
Quote:
|
Quote:
|
as per them:
replaced motor mounts, so exhaust no longer hits car anywhere. adjusted y pipe since engine is now in proper place replaced rear pinion seal since it was puking adjusted panhard properly since it was not centered replaced rear fluid since a bunch of metal came out (this will be 3rd drain and fill in like 550miles since rebuild) vibration still there 100% Steering shaft is now hitting headers really bad. Going to put LS1 steering shaft in. Also going to call Corbos (who rebuilt rear) and tell them what's going on. Not sure if I mentioned earlier, but they left pinion loose. I think they ****ed rear, but I have a feeling thats still not my vibration. i ****ing give up |
I can't say much cause I have had my bone headed moments, BUT... you have been chasing vibration issues and never mentioned or looked into shot motor mounts causing headers to hit floor boards?
|
Quote:
I'm really thinking it's in the transmission. Only thing that isn't new |
Quote:
|
Quote:
Have to see what happens with shop that did the rebuild. |
Can you give a little summary with the description of the vibration and where it is felt, followed by what has been done? It gets hard to follow in long threads
|
Quote:
Vibration slightly noticable in gear on decel. Pretty much non existent when throttle is pushed in gear |
All times are GMT -5. The time now is 01:37 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.