Mustand Dyno, lettuce be cereal here :wink:

My bad. Blame it on the lack of sleep. Fixed.

Hey guys, need your opinion on this project cause I'm about to go ahead and start the motor. If I have not mentioned already I want a street / strip car. Looking to be in the high 9's. So should I do a 408 stroker kit to this lq 6.0 block I have and run a procharger with that, or do a lsx with a prochargher?

All depends on your budget and what TTP is comfortable working with.

I believe Rob (barneymobile) runs 9s with a LQ9 block punched out with nitrous.

Anyone running wilwood brakes? I want to get the 140-9833 front kit and the 140-9830 rear brake kit. Wilwood says that both kits use factory spindles and back plates. Is anyone familiar with these brake kits?

http://i1268.photobucket.com/albums/...psi2idgbqp.jpg
http://i1268.photobucket.com/albums/...psqlyotwqa.jpg

BMR parts here are

XSB001 Xtreme anti-roll
MTA001 Chrome moly adjustable torque arm
MTCA002 Lower Control Arms, Chrome Moly
PHR004 - Panhard Rod Relocation Kit
CAB002 - Control Arm Relocation Brackets, Bolt-on
DSL001 - Driveshaft Safety Loop
SFC020 - Subframe Connector, Weld-in, 4-point

A lot of work has been done

A couple more

midwest chassis 8.5 rollcage mocked up

Nice hardware.

Nice!

Oh baby

Ooh. They look fancy.

They look wild

I still have the fronts to get. Got the weld S71b 15x4.5 on order. I decided to go with the hoosier 27x11.5x15 quick time pros for the rear and Hoosier 26x4.5x15 front runners. I spoke with madman on ls1tech, got front and rear coilovers and travel limiters coming from him, to help keep the noise not pointing to the sky.

So more than likely my wavetrac will be up for sale. It was never used, car has gone from being a street/strip car to all out strip. I placed another order with quick performance yesterday for 40 spline axles, 35 spline pinion gear and 9 and 1/2 ring gear with drag spool. Oh well, if anyone is interested let me know it's going to be the posi unit only with 28 spline pinion and the 35 spline axle shafts. 4:11 gear ratio.

some strange 40 spline pro axles for ya

and some quick time pro 28x11.5x15. I went with the 28 instead of 27

It was Christmas morning at my house today

Looks like you are ready for some wheelies. Nice!

I'd like to keep them to a minimal height. Im going to run a set of travel limiters up front and some real good coilovers. Hopefully I'm not looking up the sky.

You look like you will be running some serious times.

If all goes to plan. I should be looking at 8's

Sweet!

Been super busy with my 3 year old, but I did get some parts in. I decided to go with a polished aluminum and metallic silver look for this car. I got my wilwood drag brakes, madman wheelie bar brackets, ordered some badges from embempros. Also decided to get the polished beadlock rings on the weld wheels