driveshaft safety loop?
So I really should be running one of these but it looks like they are a bitch to fit underneath with the torque arm, 3 inch y pipe etc;
has anyone ever ran the lakewood one ? http://www.jegs.com/i/Lakewood/620/18022/10002/-1 Not looking for anything crazy something affordable and doesn't require me to re organize the underneath of my car lol |
Not sure what torque arm you have but most of the short TA come with loop or you can buy the cross member with the loop.
Also type in Spohn on Central Jersey CL there's a guy selling that Lakewood one you are talking about. |
What torque arm do you run now?
|
I had both the lakewood loop and the jegs one with the round loop both were a royal pain to install and there is not much clearance for the driveshaft. I also had to remove the driveshaft to install them. The granatelli loop is easy to install and gives you plenty of clearance. It's a little pricey but it's well worth it.
http://www.jegs.com/i/Granatelli/467/500002/10002/-1 |
stock torque arm for now
was looking at this one too per my friend's recommendation... I assume this is a PITA to install as well... http://bmrsuspension.com/?page=produ...249&superpro=0 is this ligit ?? http://www.ebay.com/itm/1993-2002-Ca...25.m3641.l6368 |
Aren't you getting a new rear? Best thing you can do is get the torque arm off of the trans. Time to pony up :lol:
|
Quote:
|
+ 1 on get that TA off the trans. Go with a short arm with the loop. If you buy one used make sure it doesn't have stress cracks.
|
I got the granatelli loop. Even if I do change the torque arm I am concerned about running the one to the frame because one kid I know's ripped out
|
Quote:
|
I'm getting the granatelli one delivered tomorrow. Do I have to take the seats out to install this (like what holes/bolts does it utilize) the one I did on a 04 mustang gt the seats had to come out cause it mounted to the seat holes..
|
The seats don't have to come out. Just take out the bolts from the cross member and you will see there are threaded inserts in the body. Looks like it bolts right into there. 13mm if I remember right.
|
Quote:
|
I have a BMR safety loop somewhere (bought it after rear u joint asploaded and killed my airbags). I never installed it lol. whats wrong with the BMR loop?
|
Quote:
|
You can just take the driveshaft off the rear, then slide it up. It doesn't need to come out of the trans.
|
Quote:
|
All times are GMT -5. The time now is 07:28 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.