Making power window door panels to manual
I'm not asking about to conversion but simply can I make the power window style panels into manual without damaging them? I can get perfect condition door panels power style. I want to make sure simply cutting a very small hole in the back and through the panel for the crank to connect can be done without damage. Suggestions on how to cut?
Thanks |
The cleanest way to make the hole would be by using a gasket punch . They come in different sizes , and I believe Harbor Freight sells them
|
use a manual panel to make a template, and cut the 1/2" hole(or close). The base of the acutal crank handle is larger at about 1 1/4" so it will hide the cut edges.
I'd suggest start with a drill bit like 3/8" the use an exacto knife to enlrage the hole until it fits the crank shaft. |
Doesnt the speaker get in the way of the handle?
|
Quote:
http://www.hermesautoparts.com/produ...,%20Right1.jpg |
I thought he drove a firebird?
|
If you look on the backside of any door panel, there is a small cutout where the crank portion passes through and a small channel for the washer to align with that goes between the handle and panel. You only have to take a razor and open up the fabric. I've only done it on a camaro and don't know if the monsoon system will complicate this.
|
Quote:
How ever It looks like the monsoon system will get in the way so i'll probably be removing the plastic housing for the speaker that runs up into the handle. i believe it's only held in with tabs/clips. Example http://i80.photobucket.com/albums/j1...ps1c4f8afc.jpg Quote:
|
Making a transmaro? Lol
|
All times are GMT -5. The time now is 10:09 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.