2001 Camaro z28 with LS3
Trans is back and built. Billet servos, 5 pin planetary, Has yank ss3600.
Asking 11k or best offer. Motivated. Will ship. Owned since 2012. Have a c6 now so need space. Made 452 hp and 426 tq on mustang dyno Tuned and alignment performed by Krazy house customs Black T-top z28 with SLP SS hood Chevy bowtie grill insert Headlights with black inlays. HID headlights and fog lights. Added side skirts and rear bumper lip Body has 155k on it PA racing chromoly K-member with removable center bar PA racing upper and lower chromoly control arms I have a set of new still in wrapping Umi black front lower control arms that can be tossed in as well ($500 new) Umi front caliper plate. C5 front brake calipers with new Power stop z26 Steert warrior front and rear brake pads and rotors. Brake lines from master to abs block to front calipers and to the rear diff were replaced with inline tubes stainless steel brake kit. Rear lines are in back seat. Qa1 single adjustable struts. Qa1 single adjustable shocks Umi drive shaft loop BMR double adjustable torque arm Umi upper adjustable strut tower plate. umi drive shaft loop Adjustable lower rear control arms. Double adjustable panhard bar Upper tubular relocation panhard bar Tsp 1 7/8 headers to tsp off-road 3 inch to 3 inch mufflex mid pipe to SLP dual dual. New bosch 13111 front 02 sensors. Cadi L something motor wit 22k converted to ls3 non vvt engine. New rings, new cam and crank bearings. Has 58x crank and 4x cam timing Lingenfelter box installed for computer to read. Ls9 head gaskets. Ls7 lifters. New trays. New pushrods. C7R timing chain Arp crank bolt Arp cam bolts Arp crank bolts. Arp intake bolts Lunati valve stem seals SLP lip to 90 or 92mm 5 wire maf ls7 coil packs Ls3 intake Ls3 knock sensors Ls3 map sensor. Ls3 valley cover with front nipple like ls6 cover to oil catch can. Ls3 timing cover Ls6 ported oil pump. Energy poly motor mounts and front sway links. Front sway bar is a spohn 32 mm chromoly sway bar. Umi bolt in subframe connectors that 3 bar spider to center on vehicle. SLP strut tower brace 160 thermostat. New water pump and under drive crank pulley. All gaskets were replaced. Ngk plugs Pac 1200 series springs New steel valve locks New retainers Trunnion upgrade for rockers Holley sniper tb 92mm Holley fuel rails 42lb injectors 236/246 .612/.612 110 lsa C4 zr1 black rims 17x9.5 in the front and 17x11 in the rear Rear is stock 10 bolt with 3.42 gears. Have a trickflow girdle for it Has a better radiator in it. Can't remember company was done 9 years ago. Secondary cooler for trans. Steel braided pump steering pump line kit. Adapter harnesses are either Kasper or katech. Knock harness, cam harness, 5 wire maf, map harness. Have a racetronix fuel pump harness that's in the backseat. Has a walboro 255 Pump. Tank was removed properly and NO fuel pump door cutting. Ac gets cold and heat gets hot. Procar sportman series driver seat |
All times are GMT -5. The time now is 03:52 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.