Need a shop...
 

I need to get plugs, wires, and a cap and rotor installed this week and need a good place to do it. I have ngk plugs and talyor wires already but i want a msd cap and rotor. Is their any place open this week that will have the cap and rotor and do an install?

summit can get one to ya in a couple days pending theyre still not on backorder...but your ass will get annihilated if you pay a shop to do that stuff, think in the range of easily more than 500 bucks...a couple guys on here will probably volunteer for some food

Once gain I'll ask what make sit necessary to take it to a shop?

I'm ok with my mechanical ability, but not too confident. I really don't have the time or a place(rather not do it outside in the cold), i also need to do plugs and wires

...not a whole lot of experiance either

Its an LT1? Id help you, but that engine is from the devil

yup LT1, and i know its tuff to work on

Go buy headers. Then pretty much anyone here will help you do plugs and wires.

- Justin

werent there more posts here last night?

Tsar you're probbly thinking of the identical thread in the north section...

If you don't mind a drive, call up Garfield Auto Center (in Garfield) its exit 61 off of 80. It's not too far from denville, bout a half hour. 973 478 2311. Ask if they can do it this week. Say your friend Melissa told you to call them, they might cut you a decent deal.

If you need directions, ask them or me, its not hard to get to.

yea i just figured that out...thanks