![]() |
slp loudmouth?
What would you have to do put a slp loud mouth on a third gen? Is it possible and How much do you think it would cost to have an exhuast shop fab up?
~matt |
I know its possible, but I dont know how much it would cost. And FWIW, I think it would sound like junk. you car doesnt have enough mods to sound really aggressive, plus its missing about 45 cubic inches :wink:
|
I would defenitly advise against putting a loud mouth on a bone stock 305. Boon (Mister-Juice) has a loud-mouth on his Iroc, but it is a far from stock 305 and it sounds amazing!
I'm pretty sure you could use a 93-95 LT1 Loud Mouth, since your LG4 is single cat'd I think theirs only a different pipe bend somewhere in the system. Also if Im not mistaken the Loud Mouth is just resonator mufflers, any exhaust shop could fabricate that into a system. |
Im about to put a camshaft into it, and install my headers or Im gonna get a 350 and install my parts.
|
Do you already have an after market cat back? if you do, just get the rear section of the loudmouth (over axle).........and some hangers....it slips right on.
it's gonna be loud.... |
Quote:
|
i have dual/dual tips..............you could also get the single/single...
|
my wifes old 305 tpi car with no muffler was actually pretty quiet...single cat if i remember correctly. So im not sure how loud just the over axle would make it.
|
If its a LG4, I threw some no-name brand on there (Vortex?) and a hi-flow cat and it sounded insanely loud... but it had absolutely NO power whatsoever :-D
|
I have dynomax now it sounds pretty cool especially when its warming up
|
SLP's loudmouth exhaust usually makes what would be really nice cars sound like domestic rice IMO. But on the same hand, I like loud and obnoxious not so many years ago. I am all about being stealthy now.
|
Quote:
|
Quote:
|
Quote:
Dont :cry: Dave your still my boy....did you get your rear fixed yet? |
Well I want it to be loud and gargle! I basically want the closest sound to open pipes but dont want to run open pipes
|
Quote:
- Justin |
Quote:
|
Quote:
|
my friend had edelbrock TES headers ( I know...I know) into an edelbrock Y pipe into a highflow cat then out an edelbrock catback. sounded pretty good for an LG4. At least thats what I think curt was running :shrug: .
you could always go mega low budget and run glasspacks :lol: |
All times are GMT -5. The time now is 02:24 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.