![]() |
Might need help with t-56 install =(...
I guess first off I should reintroduce myself.. (it'll be quick I promise lol) My name is Dan and Ive been around here on njfboa for a while.. I just dont post a lot here. I was also a member of fbody chaos and the other one nj fbody club as well (cant remember the name). Anyway.. Ive never installed a t-56 (came out of a 93/94 Z28) before and into a 3rd gen. Anybody local interested in a helping me?? I live in Passaic County. The old t-5 is out.. I'll have the t-56 flywheel and clutch bolted up..torqued down ect ect. I'd just like someone to be with me to help line up the trans.. you dont have to be there for a whole thing.. just help me get a few bolts started and I'll do the rest..
Dan |
the be a drive for me, but word of advice, make sure u put the bellhousing on BE4 the tranny body(dont do it as one peice). if u seperate them itwill go on alot easier
|
Quote:
|
thanks for the advice guys.. for those of you using the 93-97 tranny.. did get the trans lined up.. pushed foward till it was "flush" with the motor than pull it back till it was ALMOST off the spline AND then bolt up the shift fork? Im kinda wondering how the hell you're supposed to install this trans.. Im sure I can figure it out.. just gonna take time..
Dan |
When i did the clutch in my 93 it was a tuff squeze the get the fork bolted back in. If u have small hands u'll have no problem.
|
Hey Dan, how far are you from Passaic/Clifton? I might have time on Saturday to give you a hand.
|
Quote:
Dan |
i just finshed putting my t56 back in my 96 camaro with a clutchmaster stage4 clutch and i did not touch the frok i just pulled it back and slid the trany in then pushed it on to the throwout bearing no bolt it slid on that bolt no need to remove it
|
where in passaic county are you?
|
Im in West Paterson..
Dan |
All times are GMT -5. The time now is 06:15 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.