I need to borrow a few things.
 

an air compressor able to hold valves up.
Valve spring tools
crank puller.


pm me maybe we can work some thing out.

Thanks
Matt

a good air compressor is an extremely important tool to have around any garage. If I were you I would break down and buy one.. btw, its POSSIBLE to do valves and springs with a small 2.5 gallon compressor, it just takes a LOOOOONG time, so i wouldn't recommend it.

i think you're better off feeding an old spark plug wire through the spark plug hole and crushing it with the piston in order to keep the valves up

wtf is a crank puller?

the crank gear* puller my bad

I CAN SEND THIS TOOL IT IS WHAT HE WILL NEED FOR THE JOB WE MODDED IT FOR USE WITH A RATCHET OR BREAKER BAR 3/8' DRIVE --TO YOU FOR WAY FAST IF YOU ARE SENDING HIM THE PLUG WIRE -- JZ

heads are off, right now, im at a stand still so I dont need the tool just yet. I have other things to think about right now.

iT MUST BE ME I THOUGHT YOU HAD ASKED OR TALKED ABOUT A TOOL TO REMOVE THE SPRINGS WITH THE HEADS ON --- THATS WHAT THIS POST WAS ABOUT --- ???????????????? -- JZ

I did, but I just took the heads, off and Im gonna bring them some place to get the springs installed if I keep the 305