split rear seat question
 

Can anyone provide a photo or describe how the bracket that connects the split rear seat is supposed to attach. I just converted from a one piece seat. Thanks, Steve.

i know the bracket is welded on, on top of the trans tunnel in the back, as for exact location im not sure, i only have 2 3rd gen camaros here and they are 1 piece backs. most trans ams got the 2 peice and soem high optioned irocs etc

I added this to my 82 when I swapped interiors. I basically just eyeballed it and screwed it in. I did have to drill out the 2 spot welds that held the bracket in the donor car.

Put the seat backs in, then move the middle bracket until you get them stright & even. Mark it, drill it, screw it in.

split rear seat
 

Thanks guys, will do.

i just removed the split rear seats in the Z28 and the bar is welded on. i replaced with a single 4th gen piece and now the bar is kinda visable but nothin to bad

You can get that bar off. IIRC, it is spot welded on with a single spot weld on each side. I remember just kinda prying/chiseling it off, I don't think I even drilled it.