Trying to source some Intake Tubing, anyone???
 

Well I'm trying to put together a simple intake system. Anyone know where to get some 3" tubes in either aluminum/plastic with some areas straight and some with a bend? I am not looking to do a home depot mod here so no PVC piping for this project. Anyone know where to get some?

-Brian

You can get it in sections from Jeg's, Summit ect. Alum. is a bit exspensive. It you're just doing a 1-2' section you might be better off at a local exhaust shop using mild steel. It's not that much heavier and cost 1/2 the price. If you're near mufflex, they can hook you up as well. Dennis did all the tubing for my front mounted intercooler in 3" alum. It was not cheap!

If weight is an issue, you can also go stainless, but again, cost will go up.

John

i have some left over from my old mitsubishi eclipse. its
3'' and is made of polyurethane. easily dremelable for tight spots
i picked it up cheap at autozone or advanced. its like 30 bucks
for a few feet and you can buy extra pieces too...not bad, cheap
but works and stays cool nicely