NJFBOA - Home of New Jersey's Camaros and Firebirds

NJFBOA - Home of New Jersey's Camaros and Firebirds (http://www.njfboa.org/forums/index.php)
-   Transmission and Driveline (http://www.njfboa.org/forums/forumdisplay.php?f=38)
-   -   stall converter questions (http://www.njfboa.org/forums/showthread.php?t=35359)

98tadriver 07-02-2008 05:44 PM

stall converter questions
 
I might be selling a stall converter to a member on the boards here but before i do so, i need to know if its going to work.

will a stall converter that was on a 89' camaro w/ 700R4 work with this car? (below)

95 Camaro Z28 auto (4L60E)


are the splines and flywheel to tq converter bolt pattern the same? thanks in advance!

Tru2Chevy 07-02-2008 08:07 PM

AFAIK any 700R4 / 4L60 / 4L60e converter will swap from 87-97 transmissions. I think the LS1 4L60e uses a different converter.

I'm not 100% sure about this, but fairly confident.....

- Justin

Savage_Messiah 07-03-2008 12:59 PM

I'm not sure but would the lockup engageent be affected going from a non elec. to an elec. controlled trans?

GrandmasterCow 07-03-2008 02:02 PM

I think the LS1 trans uses a different length inputshaft than 700R4 and previous 4L60e. I forget if it's shorter or longer.

WildBillyT 07-03-2008 03:02 PM

Quote:

Originally Posted by GrandmasterCow (Post 461357)
I think the LS1 trans uses a different length inputshaft than 700R4 and previous 4L60e. I forget if it's shorter or longer.


If it's anything like the T56's, then it's longer.

LTb1ow 07-03-2008 04:46 PM

Well it would be going in an LT1.


All times are GMT -5. The time now is 10:55 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.