pics of gauge install
 

Installed two autometer cobalt series gauges.... electric FP and A/F ratio..narrowband for now till I can lay out the dough for wideband. Only thing left is to change the cluster bulbs to match.

http://i5.photobucket.com/albums/y15...Z/P9050013.jpg

http://i5.photobucket.com/albums/y15...Z/P9050007.jpg

Looks good. Those electric FP are not cheap. I removed my narrowband a while ago and actually should put it up for sale. I NEED a wideband right now!

looks great ted

The cobalts look nice. I can't rememberwhat I have in mine, phantoms or something.

Looks great. How difficult was the install?

:drool: damn ted! looks great! love that car

I like the Cobalt series myself. Looks real nice!

looks good ted

Thanks guys! Install wasn't bad at all, the FP gauge came with a harness so it was the only wire I had to run through the firewall, my power, ground, light, and ECM were connected under the dash. Mounting the pod required 4 1/16 holes for plastic push in clips and I used a holesaw on the A-pillar to run the wires through. Biggest pain was finding the right size fittings for the sender unit on the fuel rail lol. And those electric FP gauges aren't cheap! but I knew I wanted something so I could moniter the FP (I have an adjustable FPR still to install) and I wanted a cleaner look than mounted on the backside of the scoop, so I bit the bullet lol

looks good. and i see jeanne-marie. (sorry if i misspelled)