OTVC Plug wires
 

Looking for the OTVC kit and pre cut wires for an LT1, can anyone shoot me a link?

you have to

taylor thunder racing kit is what I used.

http://www.thunderracing.com/catalog...vid=4&pcid=104

I opted for the hand held crimper, it wasnt that bad. I'm looking for a wedsite I saved that gave all the lenghs you need.

EDIT : AHA!

http://www.lt1engine.com/tech/how-to...e-cover-wires/

no, i want precut ones. the ones you make yourself are a pain in the ass

oh ok ... sorry.

I haven't heard of anyone making them honestly. I could be wrong though.

why should i stay away from taylors? the g/fs car has them and its been fine for a few years now

:lol: yeah i have heard taylors tend to arc like crazy and the boot diameter is too small, you have to actually drill them out when making your own. the only OTVC kit that has pre cut wires i know of, would be the coil pack kits or the new LS1 pcm with coil per plug. not sure if you want to go that route. also, a guy on tech makes them. i believe he uses MSD's.

I haven't had any problems with mine.

its like offering advice you came across on here is illegal :rolleyes:

hope this helps a little
http://www.ls1tech.com/forums/lt1-lt...lug-wires.html

You all know me too well. As always- the tech sections are for technical discussions only. Matters of opinion should be backed up with fact to stop the propogation of inaccurate information.

i use taylor on alot of my builds and love em'

The only company I know of still offering Kits is Thunderracing and they only come with the universal wires you have to cut yourself. I've done a few installs and it's really not that bad if you get the crimping tool. And have had no problems with the Taylor wires.

I really don't think anyone is going to make a kit with precut wires because there can be some variations in how you route the wires. Car with TC for instance need the wires routed slightly differently, 93's route slightly different due to the air pump location the wire run down the front a bit different etc.

Note there are two styles, over the VC or on the side of the VC. The ones that run along the side make for a very clean install, BUT, they are allot of work (a real PITA!) to install!

I have a brand new set of the looms you can have, I bought them with my Taylor OVC Kit, but I didnt use them, you will have to buy the wires.