NJFBOA - Home of New Jersey's Camaros and Firebirds

NJFBOA - Home of New Jersey's Camaros and Firebirds (http://www.njfboa.org/forums/index.php)
-   Engine / Power / Tuning (http://www.njfboa.org/forums/forumdisplay.php?f=31)
-   -   lt1 head question (http://www.njfboa.org/forums/showthread.php?t=43581)

lilredjeep91 04-29-2009 10:07 AM

lt1 head question
 
My question is how much would you pay for these lt1 heads. here is the work done to them.

comp valve job
mill .004
back cut valves
cut for seals
pocket work intake exhaust
intake gasket match

LTb1ow 04-29-2009 10:11 AM

Um, is this a backyard job or a professionally done job?

Do you know the casting number?

Not much though...

lilredjeep91 04-29-2009 10:39 AM

the job was professionally done and no i dont know the casting number

WildBillyT 04-29-2009 12:28 PM

Um, bare or assembled? Sounds like assembled- if so, what hardware?

Pampered-Z 04-29-2009 01:56 PM

Find out if they are complete heads (seals, springs etc ) or not. What type/brand vales, and what size valves? If the heads were machined to accept other then stock springs, and flow numbers would be nice too.

Heads could run from around $500 to near $1,500 depending on how much port work and what parts they have in them.


If your investing in heads, I would suggest looking for larger then stock valves. Typically built heads have 2.02 1.60 valves. I also lean towards using 2 double springs (normally require the pockets machined).


All times are GMT -5. The time now is 07:43 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.